FS1330 model Water cooling high pressure air compressors for PET blow moulding machine CE

1, cast iron structure: The air cylinder and the crank case use 100% cast iron material, guarantees the unit the service life.
2, air cylinder: The deep wing piece type, the independent casting air cylinder may 360 degrees eliminations produce compressed air quantity of heat. Between the air cylinder and the crank case with the bold fastening, is advantageous for the routine maintenance and the maintenance.
3, flywheel: The flywheel leaf blade produces one kind “the tornado” the type air current to cool the deep wing piece type air cylinder, the middle chiller and the after cooler.
4, intercooler: The finned tube, the immediate packing blows in the flywheel gas place.
5, after cooler: The finned tube, the forced-air cooling type, install equally with the middle chiller in the flywheel gas blow place. Compressed air which discharges after the after cooler compared to ambient temperature high approximately about 20
6, offcenter unloading gear: Release from cold and in air cylinder's air, prevents the unit overload start.
7, adjusting device: All high-pressured unit disposes the automatic start/engine off control, moreover may choose the constant speed control and the dual controls.
8, self-refrigeration draindown system: The self-refrigeration wash water valve installs on the exhaust separator/valve's support, when the compressor engine off or unloads when the constant speed control mode, discharges the condensed water automatically.
9th, electrical machinery: TEFC, the IP54 electrical machinery, conforms to the IEC standard.
10, actuation: The entire seal shroud “V” the belt transmission, the movement is steady.
11, foundation: On the Chungking Steel Works structure's foundation opens has the groove, the electrical machinery may move, is advantageous for the fastening “V” the leather belt.
 

Specifications:

Competitive Advantage:

1. Valve: hoerbiger, keep enough air flow and long life

2. Bearing: SKF, keep steady quality

3. Electric parts: Schneider, keep quality and steady

4. Motor:Siemens, keep quality and steady

5. 24/7 continuous running, quality good enough to run all time

6. No foundation to keep use easy and save the investment cost of workshop

7. Low oil level protection, remind customer to add oil on time

8. Full automatic discharging pressure system make sure the machine start without load, 

protecting motor, electric part and other parts to keep good quality and long life

9. Water cooling & Air cooling two kinds of cooling method will keep better steady 

for PET blow moulding machine

10. Lower temperature keep water cooling air compressor have longer life and better performance 

than traditional air cooling air compressor